Brake fluid is central to your vehicle's brake system. It is the blood line and the power house of your brake. Keeping your brake fluid fresh, flushing it periodically to clean the debris out of hydraulic fluid system, renewing the system with new fluid to provide proper viscosity for optimum performance, is an integral part of your vehicle safety and maintenance. Her is how your system works:
In order to bring a vehicle to a halt, three things are necessary: leverage, hydraulic force and friction. Leverage is supplied by pressing your foot on the brake pedal. The pedal is connected by levers and rods to the back of the power booster. The power booster uses either engine vacuum or a hydraulic pump to multiply and transfer the force of your foot to the master cylinder. The master cylinder is the heart of your vehicle’s brake hydraulic system. It uses applied pressur to force a reservoir full of brake fluid through valves, brake lines and rubber hoses into hydraulic calipers and wheel cylinders. That hydraulic pressure is then used to help create friction by forcing brake pads/shoes against brake rotors/drums and this friction make your car to slow down and come to a stop. Brake fluid is the blood line of your brake system and a period drain old and fill with new is required to keep the system functioning properly.
Periodically Replacing Brake Fluid
DOT 3 and DOT 4 brake fluid are glycol based and absorb moisture over time. Moisture contamination causes the fluid boiling point to drop (which could lead to fluid boil and brake fade during hard use).
Moisture contamination also contributes to internal corrosion in the calipers, wheel cylinders, and steel brake lines. The reason for replacing fluid periodically is to get rid of contaminated fluid and restore fluid heat and corrosion resistance.
Moisture seeps in through microscopic pores in rubber seals and hoses. It also enters every time someone opens the master cylinder reservoir to check the fluid level. Most fluid reservoirs are transparent so level can be checked without having to open the lid.
Brake fluid is so hygroscopic (attracts water) that leaving the lid off a can of fresh brake fluid can ruin it overnight. It will absorb so much moisture from the air that it becomes too badly contaminated to use.
How often should the fluid be replaced? By the time a new car is only 12 months old, its brake fluid contains about 2% water. After 18 months, the water content is approaching 3%, which is enough to lower the boiling temperature by 25%. After several years of service, it is not unusual to find brake fluid containing seven to eight percent water. For this reason, many experts recommend replacing the fluid as a preventative maintenance service every two years or 24,000 miles. At the very least, it should be replaced when brakes are relined.
